3MT Direct Collets - Imperial

3MT Direct Collets - Imperial

3 morse taper collets to fit a range of different Warco milling machines.

• Quality, extremely durable milling addons.

• Range of different sizes available.

• Thread for drawbar - 3/8" Whitworth unless noted differently below.

Imperial sizes available

• 3MT 1/8" (Item No. 4351) 3/8

• 3MT 3/16" (Item No. 4352) 3/8

• 3MT 5/16" (Item No. 4353) 3/8

• 3MT 3/8" (Item No. 4336)- Tapped 12mm

• 3MT 7/16" (Item No. 4355) 3/8

• 3MT 9/16" (Item No. 4356) 3/8

• 3MT 5/8" (Item No. 4338M)  - Tapped 12mm.

About direct collets

• These collets are an alternative to the collet chuck system.

• Each direct collet is held by the machine drawbar.

• As the collet is drawn into the quill it firmly clamps around the end mill / slot drill shank.

• Both plain and threaded shank cutters can be used.

• Direct collets do not overhang which allows maximum capacity between the spindle and table.

• Collets can be purchased individually so are an affordable milling tool holder solution.

Also available

• 3MT collets in metric sizes