£7.50 Inc. VAT
Note: Almost sold out!
Quality 2 morse taper finger collets in a range of different metric sizes.
Tapped 3/8" Whitworth for drawbar, ideal for a range of different Warco milling machines.
Collets can be purchased individually and are therefore very affordable.
About direct collets
These collets are an alternative to the collet chuck system.
Each direct collet is held by the machine drawbar.
As the collet is drawn into the quill it firmly clamps around the end mill / slot drill shank.
Both plain and threaded shank cutters can be used.
Direct collets do not overhang which allows maximum capacity between the spindle and table.
These 2MT collets are also available in imperial sizes here.